Radwag WTB 2000 Precision Balance Manual do Utilizador descarregar pdf (Página 17)

• Using and set the tare value,

• Press

• Program returns to weighings mode. The inscribed tare value can

be seen on the display with „–” sign,

• Tare can be inscribed anytime in weighings mode.

Notice:

1. You cannot inscribe a new tare value when the tare value in memory

is greater than zero. In the case of trying this the <Err3> message

will be displayed and short audible signal will be emitted.

2. Users can also enter up to 9 tare values to the scale memory

(see 16.10 of his manual).

12.3. Zeroing

To ZERO the scale press: .

The scale will display zero and following pictograms:

and .

Zeroing is only possible within the scope of ±2% of full scale. While

zeroing outside the scope of ±2% you will see <Err2>. Zeroing is

possible only in stable state.

Notice:

Zeroing is possible only within the ±2% interval of the maximal range.

If zeroing is performed beyond this range the <Err2> message and

short audible signal will be emitted.

12.4. Weighings in two ranges

Switching between the I range and the II range happens automatically

(exceeding Max of the I range). Weighings in the second range is

signalled by a pictogram in the top left corner of the display.

Then weighings is done with the accuracy of the II range to the moment

of returning to zero (autozero range

) where the scale switches back

to the I range.

- 17 -

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 66 67

Bernard Koffi 30 Oct 2024 | 06:58:38

Best Manual

Radwag WTB 2000 Precision Balance Manual do Utilizador Página 17